Installation Guide

TECHNICAL DATA SHEET
R03.002_07/07/2021
Emac Complementos S.L. (Spain) [e-mail] // Emac America L.L.C. (FL,USA) [e-mail] // Emac Italia S.R.L. (Italy) [e-mail]
www.emac.es
You can nd out more information about the technical features of Emac®’s products by downloading
their Technical File from www.emac.es
If you have any query, please contact our Technical Department in [e-mail]
Technical Information
The data provided are for information only and have been obtained by our collaborator or EMAC®.
Does not constitute legal guarantee in terms of properties and / or functionality of the application of material
Novovierteaguas SP System
Lastly, if your installation contains external joins at an angle, an angle piece is available. It should be
positioned on the corner, leaving a 5-mm gap with the adjacent prole and covering this gap with the
joint piece. We recommend using silicone (*) to seal the joint.
The welding of the outer and inner corner pieces is simply to join the piece, facilitating installation and
improving its aesthetics. It is not a watertight weld, and therefore it is normal that there may be a small
separation at this point. For a correct installation, the miter must always be sealed with silicone. For
more information see the installation video.
The system’s optimum functionality is only guaranteed upon installation of all the pieces supplied,
use of silicone as a sealant and by following the installation steps described in this le and on the
installation video. .
(*) To preserve the system’s functionality, the silicone must be kept in optimum condition and replaced periodically.
This product will be installed outdoors under weather conditions so the rainwater will be a cleaner by
itself.
If you prefer cleaning the prole, use water with neutral soap and a soft cloth with no particles to
damage the surface.
Cleaning and maintenance
4/4
OUTDOOR
EXTÉRIEUR
ESTERNO
WALLS
MURS
PARETI
PAREDES
RECICLABLE
RECYCLABLE
RECYCLABLE
RICICLABILE