Owner's Manual

Cause Solution
Floppy disk drive Diskette is incorrectly inserted.
light stays on Remove the diskette and reinsert it.
Diskette is damaged.
Use another diskette or check the diskette by running Check Disk. (For detail information,
refer to the Windows Help. To open Windows Help, click the Start button, and then click
Help and Support.)
Floppy disk drive Diskette is unformatted.
can’t write to a Format the diskette. (Refer to your Windows Help in Windows. To open Windows Help,
diskette click the Start button, and then click Help and Support.)
Diskette is write-protected.
Remove the write-protection or use another diskette that is not write-protected. To
remove write-protection from a diskette, slide the small black tab on the back of the
diskette to cover the hole.
Floppy disk drive Diskette is unformatted.
can’t read the Format the diskette. (Refer to your Windows Help in Windows. To open Windows Help,
diskette click the Start button, and then click Help and Support.)
Floppy Disk Drive
Cause Solution
The monitor doesn’t The brightness and contrast controls aren’t set properly
work Adjust the brightness and contrast controls on the monitor.
The cable connecting the monitor to your computer isn’t connected properly.
Make sure that the monitor connector is properly and securely connected to the video
connector of your computer.
Monitor is not properly connected to a grounded wall outlet.
Make sure the power cord is firmly plugged into the wall outlet and into the monitor.
You have a screen blanking utility installed or your computer entered power
management mode.
Press any key or move your mouse. Your current screen will reappear.
How do I change To change the display resolution or color depth, use the Display Properties window.
the display resolution To change the display resolution and color depth, follow these steps:
or color depth? 1. Click Start, click Control Panel, click Appearance and Themes, and then click Display.
Or click the right mouse button on the empty desktop area and click Properties.
2. When the Display Properties window appears, click the Settings tab.
3. Select the color depth from the Color quality area and the resolution from the
Screen resolution area.
4. Click the OK button.
Display & Monitor
A-3
Solving Common Problems