User manual

 
Volume
(l)
0,6 0,5 0,5 0,8 1,6
Dimensions Tank
(mm)
165x90x50 175x80x40 175x80x40 180x90x45 210x120x70
Power Supply 230V~/ 50Hz 230V~/ 50 Hz 230V~/ 50 Hz 230V~/ 50 Hz 230V~/ 50 Hz
Protection Class IP 20 IP 20 IP 20 IP 20 IP 20
Max. Power
(W)
max. 30 max. 50 max. 50 max. 80 max. 100
Timer
(Min.)
7 1-9 1 - 9 1 - 9 1-9
Technical changes reserved!


• The equipment must ONLY be operated with the supply voltage indicated on the type label
on the bottom of the equipment.
• The equipment is not suitable for permanent operation.
• The ultrasonic equipment must only be operated with suf cient water  lling (approx. ¾
of the tank volume shall be  lled with water which is approx. 1 cm under upper tank rim).
• It is normal that the upper rims of the tank warm up during operation.

Fill tank with water and connect power connector with main source. For eff icient cleaning of
your goods we recommend to use certain of our cleaning adders (please refer to below listing of
cleaning adders). For the cleaning of looking glasses and prothesis please use the inlet
basket (2).
By pushing the ON switch (1) the cleaning operation can be started. The duration of cleaning
depends on the kind of dirt on the goods to be cleaned. When operating a blue LED lights up
and indicates the operation of the equipment. After approx. 7 minutes the equipment stops
automatically. If you wish to stop the equipment earlier please push the OFF switch.
After termination of the cleaning remove cleaned goods from the tank and shortly wash them up
under running water in order to remove dirt particles which may still stick to the goods.
After termination of the one or more cleaning cycles it is recommended to empty the tank, to
wash up the tank and to dry it with a cloth. Please make sure that no water can penetrate into
the equipment through the slots in the bottom of the equipment.

Please, note that when the tank is f illed with fresh water - depending on the degree of hardness
of the water - a certain operating time for the out gazing of the water shall be considered. The
best efficiency is achieved when using out gazed or distilled water.
If no distilled water is available, please operate the equipment  lled with water for approx. 5 to
10 minutes before putting goods in for cleaning.

LA NOUVELLE GENERATION DES
APPAREILS DE NETTOYAGE À ULTRASON
Emmi 04
Emmi 05 & Emmi 05P
Emmi 08 Emmi 16
• exploitation manuelle simple avee l’interrupteur ON/OFF
• Effet nettoyant extraordinaire avec de l’eau propre
* BIEN GALBÉ - HAUTE DEGRÉ D’EFFICACITÉ *

14
11