Operation Manual

19
2 Use of remote control:
Using the remote control will help you start video recording, shoot photos and turn off the camera
without operating the camera itself. While using the remote control, place its signal transmitter port
toward the infrared signal receiver light of the camera. Then you can record videos, take photos or
shut down the camera by pressing the corresponding buttons.
Waterproof Case Using Notice
 Before sealing the waterproof case, keep the camera housing’s rubber seal clean, a single hair or grain of
sand can cause a leak. You can test by closing the case without inserting the camera. Submerse the case
completely in water for about a minute. Remove the case from the water, dry off its exterior with a towel,
then open the case. If the entire interior is dry, the case is safe for use under water.
Infrared receiver light