Thanks for purchasing the Tinyhawk Freestyle . Designed in California, assembled in China.
Tinyhawk Freestyle Disclaimer Please read the disclaimer carefully before using this product. By using this product, you hereby agree to this disclaimer and signify that you have read them carefully and completely. This product is not suitable for people under the age of 18. Adult supervision is highly recommended for kids under the age of 18. Our Tinyhawk Freestyle features open-source flight controller and Electronic Speed Controllers to meet the FPV enthusiasts' need to upgrade their quad.
Tinyhawk Freestyle Table of Contents Disclaimer ................................................................................................................. 1 Precautions ............................................................................................................... 1 Support ..................................................................................................................... 1 Product specification .......................................................................
Tinyhawk Freestyle Product specification Tinyhawk Freestyle Parameter Diagonal wheelbase (without paddles) 115mm Maximum size of the aircraft (without antenna, cable tie) 180mm Aircraft weight (without battery) 53g Motor TH1103-7000KV Propeller Avan Blur 2.
Tinyhawk Freestyle Tinyhawk Freestyle Structure 2 emax-usa.
Tinyhawk Freestyle Tinyhawk Freestyle Propeller Direction and Mounting There are 2 spinning directions for Tinyhawk Freestyle propellers, Clockwise (CW) and Counter-Clockwise (CCW). When Buying a set of propellers, 2 CW and 2 CCW will be given. The blunt leading edge indicates the direction the propeller is suppose to rotate as compared to the sharp trailing edge. When mounting propellers please make sure the correct orientation shown in the diagram below.
Tinyhawk Freestyle Tinyhawk Freestyle VTX Settings Vtx Schematic and Button Diagram VTX Channel Settings with the Button 1. Normal display All LEDs on the VTX are normally off until the button is pressed. To check band and channel status click the button once quickly, and LED starts to indicate frequency band and frequency channel. First indicate the frequency band and then indicate the frequency channel. After all 2 rounds of LED display cycles, all LED will be off. 2.
Tinyhawk Freestyle Button Menu Diagram CE and FCC unlicensed user chart Unlocked FCC HAM licensed user chart * From the factory this video transmitter is designed to operate within CE and FCC unlicensed users specifications. To use the unlocked features of this VTX the user is required to have a HAM radio license or prior consent from the FCC.By purchasing this equipment, the user is agreeing that they understand these responsibilities and will operate the equipment legally.
Tinyhawk Freestyle Changing VTX setting via Betaflight OSD Tinyhawk Freestyle is equipped with SmartAudio and is already configured with stock settings. The SmartAudio line is operated on UART 2 TX. 1. Power on Tinyhawk Freestyle, goggles, and Controller. 2. Follow the tips on screen to enter the main settings menu: THROTTLE MID+ YAW LEFT+ PITCH UP to enter OSD parameter adjustment menu. as shown in Figure 2. 3. In the menu interface, switching PITCH up/down to choose menu option.
Tinyhawk Freestyle Tinyhawk Freestyle All-in-One Flight Controller Tinyhawk Freestyle’s main electronic board is shown above. This board contains a F4 flight controller with all 4 esc’s and an 8CH/16CH receiver. Emax On-Board Receiver Number of Channels: Up to 8CH/16CH using SBUS Compatibility: FrSky D8/D16 mode The receiver is programmed into the main flight controller MCU via betaflight. The bind procedure is similar and different settings can be changed in betaflight if desired.
Tinyhawk Freestyle a 3 stage switch to select flight modes: Acro, Horizon, and Angle activating in an increasing order. AUX 3 is configured for the beeper. In a high state the motors will beep. AUX 4 is set to Flip Over After Crash mode (often referred to as turtle mode). Turtle mode is set when AUX 4 is in a high state. Please configure your radio as described above or change these settings in Betaflight Configurator.
Tinyhawk Freestyle Set the Correct Settings 1. 2. 3. 4. 5. Download the latest CLI Dump File from https://emax-usa.com/ Connect Tinyhawk Freestyle to Betaflight configurator and select the CLI tab Open the CLI Dump File in a text editor and copy all the text. Paste the settings into the command bar and press enter Tinyhawk Freestyle will reconnect to Betaflight when completed 9 emax-usa.
Tinyhawk Freestyle Flight Always use caution when flying and operate in an open and controllable area. Please learn the flight controls first before powering on the aircraft to fly. Radio Stick Controls The left stick controls throttle and yaw direction of Tinyhawk Freestyle. The right stick controls pitch and roll of the aircraft. Left Stick Diagram Right Stick Diagram 10 emax-usa.
Tinyhawk Freestyle Fly Tinyhawk Freestyle Start by powering on your Radio and Goggles. Tinyhawk Freestyle comes already bound to your radio and on the right video channel matched with your goggles. Power on Tinyhawk Freestyle by sliding the battery into the battery tray and plugging it in. Once the battery is plugged in, set Tinyhawk Freestyle on a stable surface so it can calibrate. Calibration takes a few seconds then Tinyhawk Freestyle is ready to fly.
Tinyhawk Freestyle There is an on screen display (OSD) overlaying the video feed from the camera of Tinyhawk Freestyle. The OSD displays important information such as flight time and battery voltage. Pay attention to these numbers during flight to know how much battery life is left. Tinyhawk Freestyle can fly for a maximum of 4 minutes. When the battery reaches 6.4v, land Tinyhawk Freestyle. Drawing the battery below 6.4v is not suggested and can damage the battery.
Tinyhawk Freestyle Thank you for purchasing our product! Enjoy Flying Tinyhawk Freestyle. Warning: Please pay attention to your surroundings. Not Recommended for persons under 18 years of age. 13 emax-usa.