Pump Manual

3
Operating Instructions
Safety
This manual contains very important information to
know and understand. This is provided for SAFETY
and to PREVENT EQUIPMENT PROBLEMS. To help un-
derstand this information, observe the following:
Danger indicates an imminently
hazardous situation which, if not
avoided, will result in death or serious injury.
Warning indicates a potentially
hazardous situation which, if not
avoided, could result in death or serious injury.
Caution indicates a potentially
hazardous situation which, if not
avoided, may result in minor or moderate injury.
Notice indicates important infor-
mation, that if not followed, may
cause damage to equipment.
Basic Guidelines
1. Allow only trained, authorized persons who
have read and understood these operating
instructions to use this compressor pump. Fail-
ure to follow the instructions, procedures and
safety precautions in this manual can result in
accidents and injuries.
2. NEVER start or operate the compressor pump
under unsafe conditions. Tag the compres-
sor, disconnect and lock out all power to it to
prevent accidental start-up until the condition
is corrected.
3. Install, use and operate the compressor pump
only in full compliance with all pertinent OSHA
regulations and all applicable Federal, State &
Local Codes, standards and regulations.
4. NEVER modify the compressor pump and/or
controls in any way.
5. Keep a first aid kit in a convenient place. Seek
medical assistance promptly in case of injury.
Avoid infection by caring for any small cuts
and burns promptly.
Breathable Air
1. NEVER use air from this compressor pump for
breathable air except in full compliance with
OSHA Standards 29 CFR 1910 and any other
Federal, State or Local codes or regulations.
MANUAL
Read all manuals included with this
product carefully. Be thoroughly
familiar with the controls and the
proper use of the equipment.
Death or serious injury can result
from inhaling compressed air
without using proper safety
equipment. See OSHA standards
on safety equipment.
2. DO NOT use air line anti-icer systems in air
lines supplying respirators or other equip-
ment used to produce breathable air. DO NOT
discharge air from these systems in unventi-
lated or other confined areas.
Personal Protective Equipment
Be sure all operators and others around the
compressor and its controls comply with all appli-
cable OSHA, Federal, State and Local regulations,
codes and standards relating to personal protec-
tive equipment. This includes respiratory protec-
tive equipment, protection for the extremities,
protective clothing, protective shields and barri-
ers, electrical protective equipment, and personal
hearing protective equipment.
Inspection
Inspect compressor pump prior to
any use. Check for external damage
that might have occurred during
transit. Be careful of moving parts
then test pulley by turning it
freely by hand. Report any dam-
age to delivery carrier immediately.
Do not operate unit if damaged
during shipping, handling or use.
Damage may result in bursting and cause injury or
property damage.
Installation
Area
1. Install compressor pump in a clean, dry and
well-lit area. Be sure installation area can
maintain a temperature range between 35˚ -
110˚ F.
2. Insulate cold water or other low temperature
pipes that pass overhead to avoid conden-
sation dripping on compressor which could
cause rust and/or motor shorting.
DO NOT install compressor in boiler
room, paint spray room, or area
where sandblasting occurs. Make
sure inlet air is away from exhaust
fumes or other toxic, noxious or
corrosive fumes or substances.