EMAX E8 Transmitter E8 Transmitter is a new wireless controller released by EMAX. It has a built-in 2.4GHz dualband antenna and 2.4GHz RF module. The RF module supports 8 channels. The channel range is configurable and compatible with most receivers on the market. It is equipped with a wired trainer interface and simulation.
. Specifications Product model: EMAX E8 Transmitter Weight: 260g (without battery) Size: L*W*H=150x140x45mm Working voltage: 3.3V-4.2V External interface: Micro USB interface, 3.5mm audio interface (wired trainer interface) Transmitting module: built-in 2.4GHz dual-frequency FPC antenna, 2.4GHz RF transmitting module Working frequency band: 2.4GHz (2400MHz-2483.5MHz) Charging system: Built-in USB 1A linear lithium-ion battery charging system 3. Use operation 1.
4. Key operation instructions Trim Buttons When in left-hand mode (left-hand throttle): 1. L1+, L2- are the parameters "+, -" of the throttle [T] 2. L3-, L4+ are the parameters "-, +" of the direction [R] 3. R1+, R2- are the parameters "+, -" of the pitch [E] 4. R3 -, R4+ are the parameters "-, +" of the roll [A] Mode switching D8 mode: press the power switch and the "L1+" button at the same time: turn on and enter D8 mode, then the mode indicator will turn solid red.
Note: It can be turned on and charged only when the battery polarity is correct, it will not turn on or charge. Instructor port and simulator operation Trainer Port for Simulators Insert one end of 3.5mm male to male into the trainer port (3.5mm audio interface), and plug the other end into the simulator (sold separately) to output the corresponding channel value. Plug the micro USB cable into the remote control to output the corresponding channel value. 6.
Left-handed mode: the left-hand joystick, up and down for throttle adjustment, left and right for direction adjustment; the right joystick, up and down for pitch adjustment, and left and right for roll adjustment. Right-handed mode: the left joystick, up and down for pitch adjustment, left and right for roll adjustment; the right joystick, up and down for throttle adjustment, and left and right for direction adjustment.
Switch left and right hands Remove the screw and open the back cover of the E8 Transmitter housing. There is a toggle switch on the left side of the board. Set the toggle switch to "L" (left-hand throttle mode) or "R" (right-hand throttle mode), and swap the positions of the levers (the 6Pin cable connecting the joystick to the main board does not need to change positions).
8. support EMAX will continue to add and improve functions, users can check through the EMAX official website, and look forward to your good experience using this product. More information about EMAX can be found on the following official website: WWW.emax-usa.com WWW.emaxmodel.com This device complies with Part 15 of the FCC Rules.
