Energy Guide

04.24.13 Rev. 0.3a 5
MOUNTING
Use the drawing below as overall dimensions to mount the controller.
ELECTRICAL DRAWING AND LEGEND OF THE CONNECTIONS
OVERALL DIMENSIONS
161 mm
106 mm
NOTES ON THE CONNECTIONS
Respect the working technical features and
instructions on the electrical wiring; in
special way both the cables of the
temperatures probes and pressure
transducers must be isolated from the
power cables and proper RC filters must be
placed on the contactors’ coils.
Besides pay attention low voltage and high
voltage cables run on separate trunks.
- On the back side of the controller there
must be enough space for wiring and
connectors.
- The rear side of the controller must be
protected against condensation, oil and
dust.
- Don’t wash the front panel by water
injection; clean the front mylar with a soft
cloth using soap water.
NOTE: the inputs not used have to be
connected to 12-24V directly, except IN5 if
not used has not to be connected