Installation Instructions

2. Press and hold the radio throttle trim down and pitch trim down buttons on the
radio and turn easypilot on. When the green light flashes quickly then release
all buttons .
3. Bring the radio and the easypilot close and power on the easypilot then the
green light of the radio will steady light.
4. Power off the easypilot and power on again, the bind is completed.
Trim
There are trim buttons for each axis on each gimbal. Each trim adjustment will beep
the radio and a longer beep indicate the center trim. Adjust roll and pitch trim when
hovering to achieve a stable hover with no gimbal input.
Gimbal Calibration
The radio comes already pre-calibrated; however, recalibrating can help troubleshoot
some problems.
1. Make sure the radio are powered off.
2. Press and hold the yaw trim right and the roll trim left buttons . Then power on
the radio, when the radio red light flashes quickly then release all the
buttons.Do not touch any of the radio levers at this time.
3. After the red light flashes quickly 2S, the red light changes to a slowly flashing
state. At this time, manually shake the rocker to the maximum range, and then
cycle two times.
4. Click the power switch button, the green light is always on, and the gimbal
calibration is completed.