User's Manual

www.embedcard.com 6
4 Pre-Installation
Before the installation of any hardware, verify the following:
 An adequate earth connection point exists in the game cabinet.
 If the mounting surface is metal, that it is adequately earthed.
 The game credits when a coin is inserted
 The game accurately dispenses tickets
 The coin and ticket meters increment correctly
 Correct any identified faults and retest
 Disconnect the power from the game
It is vital that you are certain the game is in proper working order before beginning
the installation of the Embed hardware. This will prevent confusion later in the
process.
Never source and use wire taps or wire nuts. Wire taps cut into the wire and make a
minimal connection that will deteriorate over time leading to game credit and power
supply related problems. Wire nuts also offer a less-than-desirable connection on the
small gauge wire used in games.
We recommends that crimp type butt connectors be used for wire joins and splicing.
You will need some tools and hardware for the equipment installation and
recommend the following as a minimum.
 Multi-meter
 Drill
 5 mm drill bit
 Step drill bit up to 20mm
 Phillips screwdriver
 Wire stripper
 Crimp tool for connectors
 Butt connectors
 Cable ties
Wire Tap
Wire Nut
Butt Connector