User's Manual

www.embedcard.com 7
Vertical/Portrait Orientation
Horizontal/Landscape Orientation
5 ICR Installation
The ICR is best mounted and fixed to a location on the game that ensures it’s easily
accessible to guests. In many cases it’s recommended to mount the ICR over the
existing coin entry point as it is readily accessible and allows use of the existing hole
for cable entry.
The ICR display can be adjusted to accommodate a horizontal (with left or right card
entry) or vertical orientation. The default setting for the display orientation is vertical.
Step 1: Locate the ideal position to mount the ICR.
Step 2: Mark the spots for drilling. Use the ICR mounting template to mark the four
mounting points and the cable connection point.
Step 3: Drill the four mounting points with a 5mm drill-bit. Drill the ICR to IOC
Interface Harness connection hole with a 12.5mm step drill-bit. Clear the holes of
sharp edges to protect the harness.
Step 4: Connect the ICR to IOC Interface harness to the connector in the bottom of
the ICR. Feed this through the hole in the cabinet and position the ICR to line up with
the screw mounting holes. Insert the correct length 4mm screws into the base of the
ICR and tighten.
Step 5: If the mounting surface is metal such as coin door, ensure there is an
adequate earth connection in place. Install an extra earth connection if necessary
using earth wire and a ring terminal secured under one of the ICR mounting screws.
Be sure to remove any surface coating as required to guarantee an adequate
electrical connection.