User manual

AOAA Kit – Software User’s Guide
Page 17
Copyright 2012 © Embedded Artists AB
Figure 12 - XBee Demo Setup
Note that at least two XBee modules are needed: one on the AOAA Board acting as a gateway and the
second on the board acting as an XBee node. In Figure 12 there are three XBee modules since two
XBee nodes are connected to the gateway.
3.3.1 Setup
This setup is using an LPC1769 LPCXpresso mounted on an LPCXpresso Base Board. An XBee
module is mounted on the LPCXpresso Base Board. The LPCXpresso Base Board must have the J7
jumpers positioned correctly as shown in Figure 13.
XBee Node running on an
LPCXpresso Base Board
XBee Node running on
an AOAA Board
Gateway for the XBee
network – connected to
Android device