User manual

AOAA Kit – Software User’s Guide
Page 26
Copyright 2012 © Embedded Artists AB
Figure 25 – LPCXpresso IDE Build Project
4.4 Debugging a Project in LPCXpresso
Before attempting to debug, the AOAA Board must be powered and the LPC-Link should be connected
via the 10-pos flat cable. For instructions see sections 3.3 and 5.1.2 in the hardware user’s manual.
To debug the demo application:
1) Select the project to work with
2) Click Debug in the Quickstart Panel (under Start Here). When debugging a project, make sure
the AOAA Board is connected via LPC-Link to the PC because the application will be
downloaded to the board via LPC-Link (SWD debug interface).
1) Click (to select) project to build
2) Build/clean project