User manual

AOAA Kit - User’s Guide
Page 37
Copyright 2012 © Embedded Artists AB
Figure 24 – Create an LPC-LINK
The pictures below illustrate how to connect the 10-pos SWD/JTAG cable between the LPC-LINK and
the AOAA board. Note the orientation of the 10-pos SWD/JTAG cable in both cases.
Figure 25 – Connect LPC-LINK to the LPC1769
Separate either by physically
cutting the board, or simpler by
removing solder bumps with a
soldering iron.
Resulting SWD/JTAG
interface connector
LPC-LINK side
Target side
(shall be disconnected)
Connect to
USB on PC