User manual

AOAA Kit - User’s Guide

Page 38

Figure 26 – Connect LPC-LINK to the LPC11C24

Below are the steps to perform a program download. Normally the demo projects would be opened in

the LPCXpresso IDE and then program download is very simple. The description below assumes no

demo project that is active.

1. Make sure that the latest version of the LPCXpresso IDE is installed on the PC.

2. Connect a USB cable between the LPC-LINK and the PC, see Figure 24 above. Connect the

10-pos SWD/JTAG cable between the LPC-LINK and the debug connector of the processor

to be programmed (either the LPC1769 or the LPC11C24).

3. Make sure that the AOAA board is powered.

4. Make sure the processor to be programmed is in a mode where the debugger can take

control over the processor. This is normally the case, but if the current application uses low-

power modes there is a possibility that the SWD/JTAG interface is not enabled. If so, place

the processor in ISP bootload mode (keep pin P2.10 low on the LPC1769 while resetting the

board or keep pin PIO0_1 low on the LPC11C24 while powering up the AOAA board).

5. Click on the "Program Flash" icon from the tool bar, see picture below. The icon can be at

different places depending on window size.