Manualshelf

User manual

ManualsBrandsEMBEDDED ARTISTS ManualsDev KitsPCB design board
21222324252627282930
Low-power Application Kit (Oryx) - User’s Guide
Page 22
Copyright 2012 © Embedded Artists AB
Figure 9 – LPCXpresso IDE Program Flashing in Progress
In case flashing fails, an error message like below will be displays. This is an indication that the
debugger could not connect to the LPC11U37. The most common reason is that the LPC11U37 was in
a low-power mode where debug connection is not possible. Make sure the LPC11U37 is in
ISP/bootload mode and try again. Also make sure the small 10-pos flat cable is connected between J1
and J10.
Figure 10 – LPCXpresso IDE Program Failing to Flash