Datasheet

SPEC No.
LCP-1109027
MODEL No.
LS013B4DN04
PAGE
23
8. Module outline
8-1) Outline dimention of the 1.3” （96×96） panel with FPC type
fig.8-1 fig. 8-2
＜Recommended Connector＞
SMK (Bottom Contact) FP12 Series: CFP-4610-0150F
8-2) FPC Bend Specification
When bending FPC, bend where specified in Condition (1) and the bend R should be more than R specified in Condition
(2). FPC is not to contact glass edge, and there should be no stress to connective area between panel and FPC.
Condition (1) FPC bend recommended area: 0.8mm – 6.0mm from glass edge.
Condition (2) Minimum bend R: Inner diameter R0.45
Fig.8-3
【Remark 8-1】 Do not bend backward (toward UV protection film side)
【Remark 8-2】 Bend frequency: 3 times or less (Repeat bend condition: 180°∼ 0°)
＜Recommended Connector of 180 degree bent FPC＞
SMK （Contact side: upper side ） FP-12 series ： CFP-4510-0150F