User manual

U
U
n
n
i
i
v
v
i
i
s
s
i
i
o
o
n
n
T
T
e
e
c
c
h
h
n
n
o
o
l
l
o
o
g
g
y
y
I
I
n
n
c
c
.
.
Doc. No: SAS1-D038-A
23
the protection film before assembling it. At this time, if the OEL display
module has been stored for a long period of time, residue adhesive material of
the protection film may remain on the surface of the display panel after
removed of the film. In such case, remove the residue material by the method
introduced in the above Section 5).
12) If electric current is applied when the OEL display module is being dewed or
when it is placed under high humidity environments, the electrodes may be
corroded and be careful to avoid the above.
8.2 Storage Precautions
1) When storing OEL display modules, put them in static electricity preventive
bags avoiding exposure to direct sun light nor to lights of fluorescent lamps, etc.
and, also, avoiding high temperature and high humidity environments or low
temperature (less than 0°C) environments. (We recommend you to store these
modules in the packaged state when they were shipped from Univision
Technology Inc.)
At that time, be careful not to let water drops adhere to the packages or bags nor
let dewing occur with them.
2) If electric current is applied when water drops are adhering to the surface of the
OEL display module, when the OEL display module is being dewed or when it
is placed under high humidity environments, the electrodes may be corroded
and be careful about the above.
8.3 Designing Precautions
1) The absolute maximum ratings are the ratings which cannot be exceeded for
OEL display module, and if these values are exceeded, panel damage may be
happen.
2) To prevent occurrence of malfunctioning by noise, pay attention to satisfy the
VIL and VIH specifications and, at the same time, to make the signal line cable
as short as possible.
3) We recommend you to install excess current preventive unit (fuses, etc.) to the
power circuit (VCI). (Recommend value: 0.5A)
4) Pay sufficient attention to avoid occurrence of mutual noise interference with
the neighboring devices.
5) As for EMI, take necessary measures on the equipment side basically.
6) When fastening the OEL display module, fasten the external plastic housing
section.
7) If power supply to the OEL display module is forcibly shut down by such errors
as taking out the main battery while the OEL display panel is in operation, we
cannot guarantee the quality of this OEL display module.
8) The electric potential to be connected to the rear face of the IC chip should be
as follows: SSD1351
* Connection (contact) to any other potential than the above may lead to
rupture of the IC.