User manual

LPC3250 Developer’s Kit v2 - User’s Guide
Page 15
Copyright 2013 © Embedded Artists AB
4 OEM Base Board Design
This chapter contains information about the peripherals and general design of the OEM Base Board
and how to set the different jumpers on the board. The schematic can be downloaded in pdf format
from the support page, and is recommended to have printed out while reading this chapter.
Section naming begins with SPx, which is short for Schematic Page x.
The picture below gives an overview of the OEM Base Board design.
Figure 1 – OEM Base Board Overview
The OEM base board has been designed to support many processors in NXP’s LPC family, i.e.
different OEM boards. The signal names are general and represent the OEM base board
functionality, rather than the LPC3250 signal names. Some functionalities of the OEM Base
Board is not supported by the LPC3250, for example the CAN interface and the USB1 interface.
Debug Connectors
Expansion
Connectors
LCD Expansion
Connector
OEM Board
Connector
Serial
Interfaces
Audio
Interfaces
USB
Interfaces
Ethernet
Interface
Power
Supply
SD/MMC
connector
Pushbuttons
and LEDs
Memory Bus
Expansion
RF module
interface
on solder
side
Reset Push-button
SW1