User manual

LPC3250 Developer’s Kit v2 - User’s Guide
Page 19
Copyright 2013 © Embedded Artists AB
When working with the LPC3250 OEM Board, J7 is typically used. If an older and big footprint
JTAG debug pod is used, J8 can alternatively be used.
JP3, J9 and J10 are not used when working with LPC3250 OEM boards.
JP4 shall be open (no jumper inserted) for enabling the JTAG interface of the LPC3250 OEM board.
Also note that the LPC3250 has a JTAG interface. Not the newer SWD interface.
Figure 5 – Debug Interfaces
Trace&Debug Connectors
J9
Trace&Debug
Connectors
J10
Debug Connectors
J8
Debug
Connectors
J7
ETM Control Jumpers
JP3
Reset LED
LED17
Debug Control Jumpers
JP4