User manual

LPC4357 Developer’s Kit - User’s Guide
Page 14
Copyright 2013 © Embedded Artists AB
4 OEM Base Board Design
This chapter contains information about the peripherals and general design of the OEM Base Board
and how to set the different jumpers on the board. The schematic can be downloaded in pdf format
from the support page, and is recommended to have printed out while reading this chapter.
Section naming begins with SPx, which is short for Schematic Page x.
The picture below gives an overview of the OEM Base Board design.
Figure 3 – OEM Base Board Overview
4.1 Modifications to OEM Base Board
The OEM Base Board has been designed to be flexible. Most options can be controlled via jumpers
but some options might need soldering. Note that modifications to the board are done at own risk and
void all warranties.
Debug Connectors
Expansion
Connectors
LCD Expansion
Connector
OEM Board
Connector
Serial
Interfaces
Audio
Interfaces
USB
Interfaces
Ethernet
Interface
Power
Supply
SD/MMC
connector
Pushbuttons
and LEDs
Memory Bus
Expansion
RF module
interface
on solder
side
Reset Push-button
SW1