User manual

LPC4357 Developer’s Kit - User’s Guide

Page 40

4.26 Default Jumpers Positions

Figure 27 illustrates the default jumper positions as mounted when the board is delivered from

Embedded Artists. Default jumpers are marked with red color.

Figure 27 – OEM Base Board Default Jumper Positions

Note that the default position for the six I2S jumpers is not what is needed for the LPC4357

OEM board. Also, JP34 is in wrong position. Before working with I2S audio and the LCD

interface change the jumper settings. Remove all JP11 jumpers. Jumpers needed to change are

marked with green – this is the position they should have.

Some signals are used on different interfaces that cannot be active simultaneous. See table in next

section for information about pin usage.

Change JP34

to pos 2-3

Change JP22, JP23, JP24, JP25,

JP26, JP27, JP28 to pos 2-3

Remove all JP11 jumpers.