User manual

LPCXpresso Experiment Kit - User’s Guide
Page 13
Copyright 2013 © Embedded Artists AB
4 Kit Content
In this chapter we will take a closer look at the different components included in the LPCXpresso
Experiment Kit.
The table below contains photos and a description of all components in order to simplify identification.
Note that photos are only typical in the sense that they illustrate the components typical visual
appearance. Exact appearance can differ for the components in the kit that you have received. The
number of components shown in a picture can also differ from delivered quantity.
Most components are specified with a Digikey or Mouser equivalent. If a component gets damaged, a
new one can typically be ordered from Digikey, Mouser or any preferred component distributor. The
Digikey/Mouser number is just to get the key data of the component. The actual components in the
component kit might very well be of different brands.
Component
Description
Note
Breadboard
http://en.wikipedia.org/
wiki/Breadboard
Digikey: 438-1109-ND
Mouser: 854-BB400T
Cables, male-to-male
http://en.wikipedia.org/
wiki/Jump_wire
Prototype cables can be
ordered from Embedded
Artists web shop in 50 pcs
packages (EA-ACC-017).
Connectors for
LPCXpresso board
11mm long pins
There is another pair of
headers that looks very
similar. This pair of
connectors has longer pins.
The other pair has shorter
pins.
This pair of connectors shall
be soldered to an
LPCXpresso board to make
it experiment friendly – make
it simple to connect cables to
the pins.
There is no distributor
equivalent for this
component.