Manualshelf

User manual

ManualsBrandsEMBEDDED ARTISTS ManualsDev KitsPCB design board
141142143144145146147148149150
LPCXpresso Experiment Kit - User’s Guide
Page 149
Copyright 2013 © Embedded Artists AB
Figure 88 – LPCXpresso IDE Program Flashing in Progress
In case flashing fails, an error message like below will be displayed. This is an indication that the
debugger could not connect to the LPC111x. The most common reason is that the microcontroller is in
a low-power mode where the debug connection is disabled. Make sure the microcontroller is in
ISP/bootload mode and try again. This is accomplished by pulling pin PIO0_1 low (via 100-1000 ohm
resistor to ground).
Figure 89 – LPCXpresso IDE Program Failing to Flash