User manual

LPCXpresso Experiment Kit - User’s Guide
Page 15
Copyright 2013 © Embedded Artists AB
Schottky diode
D1, D2
1N5817
http://en.wikipedia.org/
wiki/Semiconductor_diode
http://en.wikipedia.org/
wiki/Schottky_diode
This component is polarized.
There is a ring on one pin-
side of the components
(upper side in the picture).
This is the cathode of the
diode. The other side
(bottom side) is the anode.
Diodes Inc: 1N5817-T
Digikey: 1N5817DICT-ND
Mouser: 621-1N5817
Stand-offs
H1, H2, H3, H4
These stand-offs are
mounted in each corner of
the pcb.
AVC: BS-13S
Any standard stand-off for
4mm holes will work.
Power jack
J1
This component and can
only be soldered to the pcb
(i.e., not used on the bread
board).
CUI Inc: PJ-102A
Digikey: CP-102A-ND
Connectors for
LPCXpresso board
J2
There is another pair of
headers that looks very
similar. This pair of
connectors has shorter pins.
The other pair has longer
pins.
This pair of connectors shall
be soldered to the pcb as a
socket to the LPCXpresso
board.
Sullins: PPTC271LFBN-RC
Digikey: S7025-ND
Debug connector
J3
This component and can
only be soldered to the pcb
(i.e., not used on the bread
board). Pin 1 is in the
top/upper left corner in the
picture.
There is no distributor