User manual

LPCXpresso Experiment Kit - User’s Guide
Page 18
Copyright 2013 © Embedded Artists AB
RGB-LED
LED10
http://en.wikipedia.org/
wiki/Led
This component is polarized.
There is a small cut on one
side of the plastic package.
In the component picture to
the left, the cut is on the left
side of the package.
From left to right the four
pins in the picture are:
Red-LED cathode
All LEDs anode (positive
side)
Green-LED cathode
Blue-LED cathode
Harvatek: HT-333RGBW-A
Any RGB-LED with common
anode and a low value of
blue LED V
f
(around 3.2V)
will work.
7-sigment LED, dual digit
LED9
http://en.wikipedia.org/
wiki/7-segment_display
This component is polarized.
Pin 1 is in the lower left
corner in the picture to the
left.
Lite-On Inc: LTD-4608JF
Digikey: 160-1536-5-ND
Mouser: 859-LTD-4608JF
LEDs
LED11-LED18, SMT
http://en.wikipedia.org/
wiki/Led
This is a surface mounted
component and can only be
soldered to the pcb (i.e., not
used on the bread board).
This component is polarized.
There are green marks on
the cathode side.
Harvatek: HT17-2102SURC
Possible substitute is
Kingbright: APT2012SURCK
Digikey: 754-1133-1-ND
Mouser: 604-
APT2012SURCK