User`s guide

seropt DTE serial options
This command enables the user to select from several serial protocol options.
Command format:
ping [s]
where: s =
8n1 Sets 8 data, no parity and 1 stop bit.
8n2 Sets 8 data, no parity and 2 stop bits.
8o1 Sets 8 data, odd parity and 1 stop bit.
8e1 Sets 8 data, even parity and 1 stop bit.
Upon receipt of serial characters, the modem strips the parity bit, sends the data to the
remote device where the parity bit is regenerated if parity is enabled at the remote.
This makes it possible to run parity at one end and no parity at the other end of the
link.
ping Ping test
Please refer to chapter 4 for an overview of the ping function.
Command format:
ping [n]
where: n =
[0-15] Optional unit number to ping. If not specified the current unit
number is used. The site address used corresponds to the value
set using the site command.
radar Radar test
Please refer to chapter 4 for an overview of the radar function.
Command format:
radar [n]
where: n =
[0-15] Optional unit number with which to perform the radar test. If not
specified the current unit number is used. The site address used
corresponds to the value set using the site command.
User’s Guide Configuration Commands 3-11