User's Manual
Table Of Contents
- 1 Safety Directions
- 2 Description of the System
- 3 Accessories
- 4 Operation
- 5 Check & Adjust
- 6 Care and Transport
- 7 Technical Data
- 8 Software Licence Agreement/Warranty
- Appendix A Abbreviations
- Appendix B Regional Contact Addresses
004681_002
abcde
a IR transmitter
b Button A
c Button B
d Button C
e Button D
The Tracker Pilot software has the following functions assigned to the AT
Remote Control 400.
Button Function
A Start Measurement
B Next (on Tracker Pilot wizard pages)
C Back (on Tracker Pilot wizard pages)
D Toggle between full sketch view, full DRO view and shared
view
The AT Remote Control 400 is powered by two 1.5 V AAA batteries.
☞
The battery compartment is located on the back of the AT Remote
Control 400.
1. Press the uted part of the cover of the battery compartment and
slide the cover open.
2. Insert two AAA batteries as indicated on the bottom of the bat-
tery compartment.
3. Close the cover of the battery compartment. A click indicates
when the battery compartment cover is fully closed.
Button assign-
ments
Battery replace-
ment
Description of the System 27