User's Manual
Table Of Contents
- 1 Safety Directions
- 2 Description of the System
- 3 Accessories
- 4 Operation
- 5 Check & Adjust
- 6 Care and Transport
- 7 Technical Data
- 8 Software Licence Agreement/Warranty
- Appendix A Abbreviations
- Appendix B Regional Contact Addresses
Centring of optics Value
Red-Ring Reector (RRR) < ±3μm
Break Resistant Reector (BRR)
≤ ±10 μm
Tooling Ball Reector (TBR) < ±10 μm
Reector constant (ADM) Value
Red-Ring Reector (RRR) 0.000 mm ± 0.003 mm
Break Resistant Reector (BRR)
0.00 mm ± 0.01 mm
Tooling Ball Reector (TBR) 5.30 mm ± 0.03 mm
☞
If repeatability of measurements is important, the reector
should always be used with the same orientation. The serial
number and Leica logo on the reector housing helps to main-
tain the orientation.
Description of the System 43