User's Manual
Table Of Contents
- 1 Safety Directions
- 2 Description of the System
- 3 Accessories
- 4 Operation
- 5 Check & Adjust
- 6 Care and Transport
- 7 Technical Data
- 8 Software Licence Agreement/Warranty
- Appendix A Abbreviations
- Appendix B Regional Contact Addresses
4 Operation
4.1 Setup
The rst installation of the product should be done by authorised Hexagon
personnel. Installation by unauthorised personnel may cause damage and will
make the warranty null and void.
0024614_001
1b
2
3
1a
4
1. Screw the Quick Release onto the Tracker Stand and tighten it
using the hinged hook wrench.
2.
☞
Ensure that the locking lever of the Quick Release is
in unlocked position.
Set the AT500 instrument onto the Quick Release.
3.
☞
Do not remove the locking lever of the Quick
Release while the sensor is attached to the Quick
Release.
Close the locking lever to lock the Absolute Tracker on the Quick
Release.
4. Connect the external temperature sensor to the connector of the
socket, that is labelled with “Air”. This ensures that you achieve
the highest possible measurement accuracy.
5. Connect a LAN cable (if applicable).
6. Connect the AC power supply to the connector on the socket and
to a grounded mains socket outlet.
7. To turn on the Absolute Tracker, press the power switch on the
frontpanel of the side cover.
8. The system automatically detects when the start-up cycle has n-
ished. The system will initialise automatically once the start-up
cycle has nished.
9. Start the application.
General
Setup Step-by-
step
Operation 47