User's Manual

Table Of Contents
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
In order to comply with FCC RF Exposure requirements, this device must be
installed to provide at least 5 cm separation from the human body at all
times.
Changes or modications not expressly approved by Leica Geosystems for
compliance could void the user's authority to operate the equipment.
CAN ICES-003 B/NMB-003 B
Contains IC: 22172-MORIN01; 3147A-BL654
Canada Compliance Statement
This device contains licence-exempt transmitter(s)/receiver(s) that com-
ply with Innovation, Science and Economic Development Canada’s licence-
exempt RSS(s). Operation is subject to the following two conditions:
1.
This device may not cause interference
2.
This device must accept any interference, including interference
that may cause undesired operation of the device
Canada Déclaration de Conformité
L’émetteur/récepteur exempt de licence contenu dans le présent appar-
eil est conforme aux CNR d’Innovation, Sciences et Développement
économique Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes:
1.
L’appareil ne doit pas produire de brouillage
2.
L’appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d’en compromettre le fonction-
nement
In order to comply with FCC / ISED RF Exposure requirements, this device
must be installed to provide at least 5 cm separation from the human body
at all times.
An de se conformer aux exigences d'exposition RF FCC / ISED, cet appareil
doit etre installe pour fournir au moins 5 cm de separation du corps humain
en tout temps.
This device is granted pursuant to the Japanese Radio Law (
電波法
).
This device should not be modied (otherwise the granted designation
number will become invalid).
Canada
Japan
Technical Data 67