Installation Guide

ManualsBrandsEmberglow ManualsKitchenBlower Kit for Vent-Free Firebox Models VFBC32, VFBC36 and VFBC42

BLOWER (MODEL # BL-101) FOR VENT FREE UNIVERSAL FIREBOX

MODEL NUMBERS: VFB(C)32(A,B) VFB(C)36(A,B) VFB(C)42(A,B)

Circulating Air Blower

Installation Instructions:

If the information in this manual

is not followed exactly, a ﬁre or

explosion may result causing

property damage, personal injury

or loss of life.

WARNING

T H E C H A R L E S T O N S E R I E S

Installer: Leave this manual with the appliance.

Consumer: Retain this manual for future reference.

erates chemicals known to the State

of California to cause cancer or birth

defects, or other reproductive harm.

WARNING

This product contains and/or gen-

Summary of content (8 pages)

PAGE 1
T H E C H A RL E S T O N S E R I E S BLOWER (MODEL # BL-101) FOR VENT FREE UNIVERSAL FIREBOX MODEL NUMBERS: VFB(C)32(A,B) VFB(C)36(A,B) VFB(C)42(A,B) Installation Instructions:Circulating Air Blower ! WARNING If the information in this manual is not followed exactly, a ﬁre or explosion may result causing property damage, personal injury or loss of life.
PAGE 2
I n s t a ll a t i on I ns t r u c t i o n s INSTALLER/CONSUMER SAFETY INFORMATION READ AND SAVE THESE INSTRUCTIONS. This book contains your installation instructions and should be kept in a safe place. For you to realize all of the advantages and use of the reliable service that has been engineered into your Sure Heat Manufacturing Fireplace, you must carefully follow all of the instructions contained in this manual regarding installation and operation of the ﬁreplace.
PAGE 3
Installation Instructions Optional Electrical Junction Box Junction Box Wiring If installation of an accessory blower, or other “lineVoltage” powered accessory may be desired, you should install the J-Box accessory, and wiring at the time of fireplace installation. IT WILL NOT BE PRACTICAL TO INSTALL THIS LATER! 1. Remove (2) J-Box retaining screws. (See Figure 3 ) 2. Install J-Box Assembly into Fireplace (See Figure 4 ) 3. Attach household 110 VAC supply wire to Receptacle.
PAGE 4
i n s ta l l a t i o n i n s t r u c t i o n s Step 1 Installing Blower Kit - Model BL101 Step 1. Remove Blower Access Panel. Use 1/4” nutdriver to remove four (4) screws. The access panel will be located toward the front in models VFBC32A/B, VFBC36A/B, and VFBC42A/B. Step 2 Step 2. Place Blower Cable in box. Route switch terminals through ﬁrebox side and then up and out through the switch hole on the Front Side panel on VFBC32,36 and 42.
PAGE 5
Installation Instructions Installing Blower Kit - Model BL101 (cont.) Step 5. Step 5a. a. Attach red and black wire connectors to blower motor terminals. b. Set blower through opening onto ﬁrebox bottom. Step 5c. c. Attach green ground wire to self-tapping screw to back ﬁrebox panel.
PAGE 6
NOTES:
PAGE 7
NOTES:
PAGE 8
Limited One Year Warranty Limited Warranty shall apply to the original purchaser at the original installation point only. The Blower components are warranted for one year to the original owner, subject of proof of purchase. General Warranty: This Limited Warranty will be void if the appliance is not installed by a qualiﬁed installer in accordance with the installation insructions.