Installation Guide

I n s t a l l a t i o n I n s t r u c t i o n s
INSTALLER/CONSUMER SAFETY INFORMATION
READ AND SAVE THESE INSTRUCTIONS.
This book contains your installation instructions and should be kept in a safe place. For you to
realize all of the advantages and use of the reliable service that has been engineered into your
Sure Heat Manufacturing Fireplace, you must carefully follow all of the instructions contained
in this manual regarding installation and operation of the fireplace.
It is suggested that you wear work gloves and safety glasses to protect your hands
and eyes when installing your Blower Kit.
These Instructions should be read carefully in their entirety before
beginning installation of the Blower Kit.
Electrical Junction Box
Wiring should be connected at provided junction box, in the firebox, prior to the installation of
the Blower Kit. See instruction on page 3.
Electrical Services
If an electrical supply of 120V has been roughed in to the fireplace junction box to provide for
installation of the optional blower kit, the wiring should be connected to the junction box.
NOTE: A FEW BASIC SAFETY RULES BEFORE YOU START:
A. Make sure you have and are using/wearing proper personal safety devices such as, but
not limited to: gloves, safety eye glasses/eye protection.
B. Check to ensure that electrical service has been provided to the junction box located in the
bottom chamber of the firebox.
C. Check local building codes before installation of the Blower Kit.
D. All wiring must be installed and/or inspected as necessary to comply with the local
authority having jurisdiction.
E. The circuit breaker controlling the power supply to the pre-wired junction box in the appliance
must be in the “OFF” position before beginning installation of the Blower Kit.
2