Installation Guide

Installing Blower Kit - Model BL101

Step 1. Remove Blower Access Panel. Use

1/4” nutdriver to remove four (4) screws.

The access panel will be located toward

the front in models VFBC32A/B,

VFBC36A/B, and VFBC42A/B.

Step 2. Place Blower Cable in box. Route switch

terminals through ﬁrebox side and then

up and out through the switch hole on

the Front Side panel on VFBC32,36 and 42.

The switch will be located in the front right

corner of the fireplace floor on VFBC32A

VFBC36A, and VFBC42A.

Step 3. Slide connectors onto the spades on the back

of the switch (wires can be connected to either

terminal). Bend tabs slightly downward only on

VFBC32,36 and 42 (Non “A/B” models)..

Step 4. Slide Switch and wire terminals back into the

switch hole. Firmly seat the switch to lock in place.

Step 1

Step 2

Step 3

Step 4

i n s t a l l a t i o n i n s t r u c t i o n s