Installation Guide

Installing Blower Kit - Model BL101 (cont.)
Step 5. a. Attach red and black wire connectors to
blower motor terminals.
b. Set blower through opening
onto firebox bottom.
c. Attach green ground
wire to self-tapping screw
to back firebox panel.
DANGER:
DO NOT ATTACH RED
OR BLACK WIRE TO
BACK FIREBOX PANEL!
Step 6. Peel off backing of Velcro hold down pads, insert
blower into unit, align properly, and firmly press
down to attach to Firebox Base.
On models VFBC32,36 and 42 the velcro will be
facing the fireplace floor with the outlet of the blower
pointed rearward. Models VFBC32A/B, VFBC36A/B,
and VFBC42A/B: the velcro will be between the blower
and fireplace back with outlet of the blower pointing
upward.
Step 7. Plug Blower Power Cable into supplied
receptacle. Turn power “ON” and test unit.
Step 8. Replace Blower Access Panel.
NOTE: If you are uncertain or unclear with
any instructions or parts, STOP and
immediately contact the seller or manufacturer
listed on these instructions for further
explanation and/or direction.
Customer Service [phone]
!
Step 5a.
Step 5c.
Self-tapping screw
Step 6.
Step 7.
Step 8.
M
FIREBOX ENCLOSURE
INSTALLER CONNECT TO
110VAC HOUSE WIRING
PER APPLICABLE
LOCAL CODES
BLOWER MOTOR ACCESSORY
SPST BLOWER SWITCH
STEEL HANDI-BOX
W/SINGLE GANG
RECEPTACLE
WIRING DIAGRAM
- ALL SIZES -
5
I n s t a l l a t i o n I n s t r u c t i o n s