Installation Guide

G.
(See Figure 7)
H. The valve assembly can be rotated to better conceal the controls. Simply rotate the entire valve assembly
by turning the top 3/8" Street Elbow with a wrench. (See Figure 10)
I. Attach Pilot Burner Assembly (Part #5) to the Pilot Bracket (Part #6) (See Figure 4B on the previous page),
using the bolts (Part #8) and nuts (Part #9). Carefully bend the Pilot tubing (Part #11) when attaching the
Pilot Burner Assembly to the Burner Pan. Care should be taken not to kink the tubing, which would restrict
NOTE: The Pilot Bracket utilizes four mounting holes for adjustment of the Pilot Burner Assembly should
your installation require repositioning. Repositioning of the Pilot Burner
Assembly may be necessary if the log set is experiencing intermittent
shutdown. Shutdown is caused by overheating of the Pilot Burner
Assembly by the main burner flame. If shut down is occurring, move
the Pilot Burner Assembly over to the next mounting hole so that only
the tips of the Pilot Burner Assembly are hanging over the Burner Pan.
J. noC saG eht htiw naP renruB delbmessa eht ecalP trol Valve back in
the center of the fireplace.
K. Connect the 1/2" gas supply line from the fireplace to the 3/8" flare
fitting on valve with the 3/8" Flared Tubing supplied with the gas
log set. Refer to the General Installation Instructions section titled
“Connecting Gas Supply to Burner Pan” for full instructions.
L. Test connections for leaks with soapy water. Retighten if necessary,
and retest the connections to determine if any other leaks are present.
Figure 8
Figure 7
cont.
3
Using pipe sealant the 3” Nipple (Part #15) to the 3/8” Street Elbow attached to the valve assembly and
to the 3/8" Female Elbow (Part #16). Connect the 3/8" Female elbow, which is now connected to the entire
Using pipe sealant on threads.
Gas Inlet from
Gas Supply
Gas Outlet to
Burner Pan
Figure 6
INSTALLATION ON DUAL BURNER SYSTEMS
Burner Tube
(Heat Shield removed for clarity)
Control Valve
(Knob removed for clarity)
Burner Pan
Log Grate
Pilot Assembly
Figure 10
Figure 9
N. Spread Glowing Embers (Log Kit Part #17) evenly over
the top of the granules covering the entire surface area,
concentrating on the front and sides of the burner pan as
shown
for the most realistic burning effect.
(Figures 8 & 9)
.
P
.
. Place Log Grate (Log Kit Part #7) over the Burner Pan, al-
igning as shown in Figure 8B.
O.
Attach Back Log Standoff (Log Kit Part #18) to the back
part of the grate (See Figure 8B).
M. Spread granules (Log Kit Part #16) over the installed burner pan. Granules should be sloped to the same
angle as the burner pan filling the entire pan (See Figure
8A).
valve assembly to the Burner Orifice.
gas flow to the Pilot Burner.