Instructions / Assembly

BATTERY INSTALLATION AND OPERATION INSTRUCTIONS
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS DO
NOT ATTEMPT TO INSTALL OR OPERATE
This remote control system was developed to provide safe, reliable, user-friendly remote control system for
gas heating decorative appliances.
The system can be operated manually from the transmitter.
ON/OFF
H/M/L
WALL CLIP
SLOT
12V
BATTERY
COMPARTMENT
FRON T BACK
SIGNAL
LIGHT
ON/OFF
BUTTO N
HI/MED/LO
BUTTON
The transmitter operates on a 12V (A23) battery that is included. Install
the 12V battery
supplied with the unit into the battery compartment. It is
recommended that ALKALINE batteries always be used for this product.
Be sure the batteries are installed with the (+) and (-) ends facing
the correct direction.
The LED signal light should illuminate when either the
ON/OFF
or
HI/MEDIUM/LOW
button is pressed. If the signal light does not
illuminate, check the position of the transmitter’s battery, and if
the battery is fully charged.
TRANSMITTER
ON/OFF
H/M/L
1
2
KEY SETTINGS
ON/OFF -1.
This turns the appliance on or off.
H/M/L -2.
This controls the height of the flame. It has three levels;
IMPORTANT:
THE REMOTE RECEIVER SHOULD BE POSITIONED WHERE AMBIENT
TEMPERATURES DO NOT EXCEED 130º F.
RECEIVER
Install the (4) AA-size batteries supplied with the unit. It is recommended that ALKALINE batteries always be
used for this product.
Be sure the batteries are installed with the (+) and (-) ends facing
the correct direction.
REMOTE
LEARN
ADJ.
Requires 4-AA 1.5V
alkaline batteries
Learning
button
Frequency
adjusting
access hole
Remote Receiver
Battery cover slides on/off
Slide
Switch
REMOTE
OFF
OFF
The remote receiver has a 2-position slide switch for selecting the
mode of operation,
which is
OFF/REMOTE
REMOTE
•
: The receiver must be in this position if you want to use
The transmitter must be used to turn on the appliance.
respond to the transmitter on initial use, check the
battery positions in the remote. If that does not work, see the
OFF
•
: will disable the remote receiver.
It is suggested that the slide switch be placed in the OFF pos-
ition if you will be away from your home for an extended period
of time to preserve battery life.
High, Medium, and Low
the appliance,
LEARNING TRANSMITTER TO RECEIVER section.