Instructions / Assembly

CONNECTING THE RECEIVER TO THE VA LVE KIT
Do not install the (4) AA batteries into the receiver until the DC Step Motor is connected to the receiver.•
The receiver will calibrate
the step motor once the batteries are installed.
Connect the 4-pin female connector from the DC step motor to the 4-pin male connector on the wire harness.
•
Connect the 4-pin female connector on the wire harness to the 4-pin connector on the back of the receiver.•
Install the (4) AA batteries in to the receiver.•
After receiver is connected to the DC step motor using the supplied wire harness, make sure the plastic
receiver shield (Included)
•
is located over the receiver, then locate the receiver in an area that will not
exceed the 130° F. This location will always be away from the AF-LMF, towards the front of the firebox.
Flat 4 Wire with
4 pin Female
Connector
Flat 4 Wire with
4 pin Male
Connector
Receiver Back
Flat 4 Wire with
4 pin Female
Connecto
Flat 4 Wire with
4 pin Male
Connector
THERMO-SAFETY FEATURE
When the ambient temperature inside the receiver case reaches 130°F
, the RECEIVER will automatically send
power to the step motor on the valve to shut the fireplace system off and the RECEIVER will begin emitting a
series of 4 “beeps” every 2 seconds. When the ambient temperature at the RECEIVER drops between 120° F
the user can reactivate the fireplace by pushing
ON/OFF
button on the transmitter. When the ON/OFF button
is pressed, the THERMISTOR “resets” itself and the fireplace will begin operating gain. However, the “beep-
ing” will continue if the ambient temperature remains between 120° F and 130° F. This “beeping” alerts
the user that the RECEIVER should be repositioned so the ambient temperature drops below 120° F. When
The temperature drops below 120° F, and the control is reset by pressing the ON/OFF
button, the “beeping”
LEARNING TRANSMITTER TO RECEIVER
This transmitter has one of 256 unique security codes. It may be necessary to program the remote receiver
to learn the security code of the transmitter upon initial use, if batteries are replaced, or if using a replacement
NOTE:
This receiver can hold up to 3 transmitter codes. This is for the times when a second hand held trans-
mitter is required.
Make sure the receiver’s slide switch is in the
•
REMOTE
position.
Press and release the •
LEARN button on the receiver.
When you hear the “Beep”, press and hold the
•
ON/OFF
or H/M/L
button for about 2 seconds on the transmitter.
You will then hear a series of beeps that indicate that your new transmitter has been accepted by the receiver.
•
If you press the
•
LEARN button on the receiver and you hear no beeps, the receiver is unable to retain any
more transmitter codes (make sure that the transmitter and the receiver batteries are properly installed and
To delete all of the transmitter codes on your receiver, press and hold the
•
LEARN
button for 10 seconds.
Then you will hear a series of beeps, indicating that the receiver’s memory has been cleared.
Connector
will cease.
transmitter.
fully charged).