Specifications

Page | 11
4 WinCE Operating System
This chapter will introduce how to update an SD card and NAND Flash then
boot the Linux system from them respectively.
4.1 Updating SD Card and Booting from It
1. Please refer to step 1 in section 3.1 to format an SD card, and
then Copy the files MLO, EBOOTSD.nb0 and NK.bin from
X:\WINCE600\image\ (where X is label of your DVD drive) to
the SD card;
2. Insert the SD card into the SBC8140 and power it on while
pressing and holding the BOOT button (refer to Figure 1 to find
the button); When you see the terminal information counting
down in seconds, press the Space key on your PC’s keyboard to
enter the eboot menu.
Hit any key to stop autoboot: 0 (press Space key to enter eboot menu)
1） Type a in the following eboot menu;
-----------------------------------------------------------
---------------------
Main Menu
-----------------------------------------------------------
---------------------
[1] Show Current Settings
[2] Select Boot Device
[3] Select KITL (Debug) Device
[4] Network Settings
[5] SDCard Settings
[6] Set Device ID
[7] Save Settings
[8] Flash Management
[9] Enable/Disable OAL Retail Messages
[a] Select Display Resolution
[0] Exit and Continue
Selection:a