User manual

Page | 95
10_ARMV4I_Release to an SD card and insert it into the
SBC8140, then power on the kit;
4. Press the Space key on your PC’s keyboard to enter the eboot
menu and type a to select a proper graphic output, and then
type the number 0 to boot the system;
4.4 Introduction to Drivers
The figure shown below illustrates the architecture of the BSP for the
SBC8140;
Figure 21: BSP Architecture
The following table lists the paths of all the driver source code in the BSP;
Driver Names
Paths
NLED driver
bsp\mini8510\SRC\DRIVERS\NLED
GPIO
bsp\mini8510\SRC\DRIVERS\GPIO
bsp\COMMON_TI_V1\COMMON_TI\GPIO
I2C
bsp\COMMON_TI_V1\COMMON_TI\OAL\OMAP_OALI2C
bsp\COMMON_TI_V1\COMMON_TI\CEDDK\I2C