User manual

Page | 102
[8] DVI 1280x720 60Hz
[0] Exit and Continue
Selection (actual LCD 480x272 60Hz):4
7. Type 7 and y in the following menu to save settings, and then
type the number 0 to continue booting the system;
Main Menu
-----------------------------------------------------------
---------------------
[1] Show Current Settings
[2] Select Boot Device
[3] Select KITL (Debug) Device
[4] Network Settings
[5] SDCard Settings
[6] Set Device ID
[7] Save Settings
[8] Flash Management
[9] Enable/Disable OAL Retail Messages
[a] Select Display Resolution
[0] Exit and Continue
Selection:0
Once the booting process is completed, the WinCE system is updated and
booted up successfully.
Note:
 By default the SBC8140 boots from NAND Flash; pressing and holding the
BOOT button before connecting the power can force it to boot from an SD
card.
4.5.2 Updating the System in NAND Flash
1. Formatting an SD Card;