User's Manual

Regulatory Compliance
5.3 FCC: Data
FCC ID: Z7H-EMBLR1302
Brand: Embit
Model: EMB-LR1302-mPCIe
Power supply: 5V VDC
Transmission frequency: 902-928 MHz
The device complies with part 15 of the FCC Rules. Operation is subjected to the following
2 conditions: (1) this device may not cause harmful interference and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
5.4 FCC: Maximum Output power
The FCC regulation allows for up to 30 dB or output power plus up to 6 dBi of assembly
gain which translates into up to +36 dBm of EIRP. The modules EMB-LR1302-mPCIe can
output up to +27 dBm and so, when using the allowed antenna ,
will have no problems with the output power limit. Spurious emission and spectral density
doesn't limit the output power neither on the EMB-LR1302-mPCIe and so every output
power setting can be used.
5.5 FCC: Device labeling
Please notice that if the FCC identification number is not visible when the module is
installed inside another device, the device into which the module is installed must display
a label referring to the enclosed module. This exterior label can use wording such as the
following: “Contains FCC ID: Z7H-EMBLR1302” or similar.
User Manual EMB-LR1302-mPCIe Page 11 of 14