User`s guide

Appendix B Software Upgrade

162 Emblaze VCON HD3000 User’s Guide

B.4 Installer Mode

If for some reason the upgrade was not successfully completed, HD3000 enters

Installer Mode after it restarts.

1. Verify that you’ve entered the correct Network information before running

the upgrade program again.

3. Rerun the upgrade process from the HD Upgrade Utility. Be sure to enter

the correct IP address for the HD3000.

2. Write down or copy the IP address of the HD3000. Press <OK>.

If this process is unsuccessful again, contact Emblaze VCON’s Technical

Support (see “Emblaze VCON Technical Support” on page viii).