Portable Media Storage User Manual
PowerPath Checklist - Existing HP-UX Server and Existing Storage System
2-37
HP-UX Installation Checklist
8 FC4500 Storage
System
Set properties for
PowerPath
For a server with registered HBAs
Perform this task
either
• across the LAN connected to the
Navisphere portal for the storage
system,
or
• from an attached host or a host
networked to an attached host,
or
• from a laptop connected to a
storage-system serial port, as
described in the storage-system
setup guide.
For a server with any HBAs
Perform this task
either
• from an attached host or a host
networked to an attached host,
or
• from a laptop connected to a
storage-system serial port, as
described in the storage-system
setup guide.
Across LAN
❑
Use Navisphere Manager’s
Failover Setup Wizard (selected
from the Tools menu on the
toolbar) to set the following
storage-system properties for the
server’s existing HBA ports
(initiators):
Failover mode to 1
Array commpath to Enabled
Navisphere Manager
administrator’s guide
and online help
From an attached host or networked
host
❑
Use the following Navisphere CLI
commands to set the following
storage-system properties for the
server’s existing HBA existing
ports (initiators):
navicli -d
device
-h
hostname
storagegroup -sethost
-
failovermode 1
navicli -d
device
-h
hostname
storagegroup -sethost
-arraycommpath 1
where
device
is the storage system’s
name
hostname
is the server’s name or
network address.
From an attached or networked host
❑
Use the following Navisphere CLI
commands to set the following
default storage-system properties:
navicli -d
device
-h
hostname
failovermode 1
navicli -d
device
-h
hostname
arraycommpath 1
where
device
is the storage system’s
name
hostname
is the server’s name or
network address.
Navisphere CLI
reference
Task
With Access Logix Without Access Logix Reference Document