Model 3110B Biconical Antenna MANUAL © EMC TEST SYSTEMS, L.P.
MODEL 3110B BICONICAL ANTENNA EMC Test Systems, L.P. reserves the right to make changes to any product described herein in order to improve function, design or for any other reason. Nothing contained herein shall constitute EMC Test Systems, L.P. assuming any liability whatsoever arising out of the application or use of any product or circuit described herein. EMC Test Systems, L.P. does not convey any license under its patent rights or the rights of others. © Copyright 2002 by EMC Test Systems, L.P.
MODEL 3110B BICONICAL ANTENNA Table of Contents INTRODUCTION.................................................................................................................................. 1 ASSEMBLY INSTRUCTIONS.............................................................................................................. 1 MOUNTING INSTRUCTIONS............................................................................................................. 2 APPLICATION........................................
MODEL 3110B BICONICAL ANTENNA © EMC TEST SYSTEMS, L.P.
MODEL 3110B BICONICAL ANTENNA Introduction INTRODUCTION The ETS-Lindgren EMCO brand Model 3110B Biconical Antenna is specifically designed for radiated emissions testing. This high performance, receive only, antenna operates with in a frequency range of 30 to 300 MHz. The biconical elements are made from aluminum rods and are welded into a fixed assembly. The elements mount onto a balun network which is fabricated of aluminum and the necessary impedance-matching components.
Mounting Instructions MODEL 3110B BICONICAL ANTENNA Step 3. Repeat Steps 1 and 2 with the other washer and biconical element . Now you are ready to mount the antenna on a tripod for testing. Belleville Washer Balun Biconical Element Clamp (Open Position) Output Connector MOUNTING INSTRUCTIONS The mounting clamp of the Model 3110B uses standard 7/8x14 threads and comes with a 1/4x20 thread adapter for versatility when connecting to an ETS tripod or most other tripods for support.
MODEL 3110B BICONICAL ANTENNA Application APPLICATION The Model 3110B is ideally suited for swept site attenuation measurements per ANSI and FCC specifications. Also, the Model 3110B can be used for horizontal as well as vertical site attenuation measurements. A 20 dB pre-amp is recommended in line with the receive antenna to minimize the required transmitted power and to reduce the possibility of saturation of the transmitting antenna.
Typical Data MODEL 3110B BICONICAL ANTENNA TYPICAL DATA 1m 3 m 10 m 25 dB 1/m 20 15 10 5 30 60 90 120 150 180 210 240 270 300 Frequency (Mhz) Model 3110B Antenna Factor 1m 3 m 10 m 10 5 dB 0 -5 -10 -15 -20 30 60 90 120 150 180 210 240 270 300 Frequency (Mhz) Model 3110B Gain 4 © EMC TEST SYSTEMS, L.P.
MODEL 3110B BICONICAL ANTENNA Typical Data 15 13 11 9 7 5 3 1 30 60 90 120 150 180 210 240 270 300 Frequency (Mhz) Model 3110B VSWR 200 180 degrees 160 140 120 100 80 60 40 30 60 90 120 150 180 210 240 270 300 Frequency (Mhz) Model 3110B Half Power Beamwidth © EMC TEST SYSTEMS, L.P.
Specifications MODEL 3110B BICONICAL ANTENNA SPECIFICATIONS Electrical Frequency Range 30 to 300 MHz VSWR Ratio (AVG) 2.0:1 Maximum Continuous Power 250 mW Peak Power NA Impedance 50 V Connector Type N female Width 132.1 cm 52.0 in 55.9 cm 22.0 in Physical Depth Diameter 52.0 cm 20.5 in Weight 2.7 kg 6.0 lb NOTE: ETS-Lindgren recommends using a 6DB pad attached to the end of the antenna, otherwise high VSWR may occur. 6 © EMC TEST SYSTEMS, L.P.
MODEL 3110B BICONICAL ANTENNA Maintenance MAINTENANCE To ensure reliable and repeatable long-term performance, annual recalibration of your antenna by ETS-Lindgren’s experienced technicians is recommended. Our staff can recalibrate almost any type or brand of antenna. Please call to receive a Service Order Number prior to sending an antenna to us for calibration. For more information about our calibration services or to place an order for antenna calibration visit our calibration website at http://www.
Warranty Statement MODEL 3110B BICONICAL ANTENNA WARRANTY STATEMENT EMC Test Systems, L.P., hereinafter referred to as the Seller, warrants that standard EMCO products are free from defect in materials and workmanship for a period of two (2) years from date of shipment.