Server Support Products for Solaris Server Installation Guide

You cannot use this switch in conjunction with

the -user|-u, -password|-p ,and-scope|-s switches.

-port 443|2163

Specifies the Navisphere Management

Server port number. The default is 443.

-directory outputdirectory

Specifies the directory to which you want to deposit the report on the

server. This switch is required only if you are running the server utility

from the CD. Otherwise the report is automatically saved to the

Navisphere Server Utility installation directory.

Note: If the server utility is installed on your server and you specify a directory,

the directory you specify will override the server utility’s installation directory.

After uploading the HA report

In addition to running the server utility to validate server high

availability, we strongly recommend that you perform the following

manual checks.

 Verify support of software and hardware —Makesurethatyou

have verified that all software and hardware is supported according

to EMC’s E-Lab™ Interoperability Navigator and support matrices.

Note:Thisto

ol does not verify that you are running supported switch

firmware, n

or does it check that you are using redundant switches

(recommend

ed).

 Upgrading s

torage–system software — If you are about to perform

astorage-s

ystem online software upgrade or you added an HBA, a

LUN, or chan

ged connectivity (added a path or changed zoning):

z Make sure th

at you have validated all software and hardware

are support

ed and interoperable according to EMC E-Lab

Interoper

ability Navigator and support matrices.

z Veri fy t ha

t all LUNs (virtual disks) that your servers will access

during the

upgrade are under path management software

control. F

or servers running PowerPath and DMP, see the

Failover

Software section on the Details tab of the report and

EMC CLARiiON Server Support Products for Solaris Server Installation Guide