QUICK START GUIDE [ Quick Start Guide ] FIBRE CHANNEL HBA INSTALLATION d
Quick Start Guide Installation Instructions This Quick Start Guide describes how to install and configure your new QLogic SANblade® host bus adapter (HBA) in four simple steps: ❑ Step 1. Verify the package contents. ❑ Step 2. Install the HBA hardware. ❑ Step 3. Install the HBA driver. ❑ Step 4. Install the SANsurfer FC HBA Manager. CAUTION! Keep the HBA in the antistatic bag until installation. The HBA contains parts that can be damaged by electrostatic discharge (ESD).
HBA LEVER 64-BIT PCI-X SLOT OR SCREW x4 PCI EXPRESS SLOT HBA RETAINING BRACKET SLOT COVERS SYSTEM CHASSIS Sample motherboard and slots Step 3. Install the HBA Driver After you have completed the hardware installation and turned on the computer, insert the SANsurfer CD into your CD-ROM drive and follow the instructions below. NOTE: If the auto-run screen does not appear, double-click the start_here html file on the CD. To install the HBA driver from the SANsurfer CD: 1.
Congratulations! You have successfully installed your QLogic HBA! ❑ To obtain the most current drivers, management tools, user instructions, and documentation, please visit the QLogic website at www.qlogic.com/go/fchba and download the latest versions. ❑ The following section contains additional information about the SANblade QLogic HBA, including the LED scheme, troubleshooting, warranty, technical support and certification information.
QLA210 HBA LED Scheme Green LED Amber LED ❍ ❍ Power off Activity ● ● Power ● ❍ Online ❍ ● Link ❍ Flashing Loss of synchronization Alternate flashing Alternate flashing Firmware error ❍ Flashing Beacon QEM2462 Power and Attention Switch LED Scheme Green Power Activity ❍ Power off Insertion or removal of the adapter is permitted. ● Power Insertion or removal of the adapter is NOT permitted.
Laser Safety FDA Notice This product complies with DHHS Rules 21CFR Chapter I,Subchapter J. This product has been designed and manufactured according to IEC60825-1 on the safety label of laser product.
This is a Class A product. In a domestic environment, this product may cause radio interference, in which case, the user may be required to take adequate measures.
© 2005-2006 QLogic Corporation. QLogic, the QLogic logo, and SANblade are registered trademarks of QLogic Corporation. SANsurfer is a trademark of QLogic Corporation. All other trademarks are the property of their respective companies. Information supplied by QLogic is believed to be accurate and reliable. QLogic Corporation assumes no responsibility for any errors in this brochure. QLogic Corporation reserves the right, without notice, to make changes in product design or specifications.
QLogic Corporation 949.389.6000 26650 Aliso Viejo Parkway www.qlogic.
