System information

11 of 114Release 7.0VNX™ System Operations
7. Connect the power cables for the Control Station(s) to the PDP. In the example illustration
provided in step 6, these are power cables 1 and 2.
8. If the system power LED (D in the following figure) on the front of the Control Station
indicates that the Control Station is off, turn on the Control Station by pressing the Power
button (B) on the front. Ensure that the Control Station is powered up before continuing.
Note: The front bezel must be removed to access the Power button of the Control Station.
9. Check the system and hardware status as follows:
a. From a browser, type the IP address of the primary Control Station.
b. Log in to the Unisphere software as sysadmin and define the scope as Global.
c. Use the drop-down list at the topleft Dashboard to select the system name and view its
System Information page.
d. On this page, verify that the Status fields for the VNX display OK.
Step Action
CBADEFG
Control Station (front) Power button CNS-000876