System information

VNX™ System Operations28 of 114 Release 7.0
5. Restart the Control Station.
Restart the Control Station by pressing the Power button in the front of the Control
Station. To reach the Power button on the Control Station, you have to remove the front
bezel.
Once the Control Station restarts, go on to the next step.
6. Verify the shutdown of the blades:
Wait for 5 minutes, and then log in as root at the login prompt. Then verify the shutdown of
the blades by running the following command:
# /nasmcd/sbin/getreason
Sample output for a four blade configuration:
6 - slot_0 primary control station
- slot_2 powered off
- slot_3 powered off
- slot_4 powered off
- slot_5 powered off
7. If you want to power down the storage array, follow the powerdown instructions in the
array documentation, at this time.
8. Run the following command to halt the Control Station:
# /sbin/halt
Sample Output:
# /sbin/halt
Broadcast message from root (ttyS1) (Fri Feb 13 17:53:59 2009):
The system is going down for system halt NOW!
INIT: Stopping HAL daemon: [OK]
Stopping system message bus: [OK]
........
........
Halting system...
md: stopping all md devices.
md: md0 switched to read-only mode.
Shutdown: hda
System halted.
Step Action
Control Station (front) Power button CNS-000876