System information

VNX™ System Operations34 of 114 Release 7.0
3. Wait 5 minutes.
4. Use the SPS power switches to power off the storage system. .
Wait two minutes to allow the storage system to write its cache to disk. Make sure that the
SPS power indicators are off before continuing.The storage system will power down
within 2 minutes.
For systems with a single SPS, after waiting two minutes, unplug the SP B and DAE 0
LCC B power cables from the PDU.
5. Disconnect the power cables that run from the Standby Power Supplies to the DAE.
Note: This turns off the power to the SPS and the DPE. If the intent is to power off the
entire array, then shutdown each DAE as well.
6. If there are multiple DAEs, disconnect the power cables from each DAE to the PDP. This
powers down the DAEs.
Step Action
CIP-001115
SPS power
switch A
SPS power
switch B